Današnja pitanja i odgovori nam se javljaju zahvaljujući SuperUseru - podjele Stack Exchange-a, zajednice-driven grupiranja Q & A web stranica.
Fotografija ljubaznošću gittä_46 (Flickr).
Pitanje
SuperUser čitač Space Ghost želi znati hoće li pristupiti BIOS-u ili CMOS-u tijekom pokretanja:
For the longest time I have assumed I was entering the BIOS setup and that CMOS is a chip that holds the BIOS settings I set/choose in its memory.
I recently read somewhere that when I am configuring boot order, etc. that it is actually the CMOS setup. I am a little bit confused now, could someone explain this to me?
Je li Space Ghost pristupio BIOS-u ili CMOS-u tijekom pokretanja?
Odgovor
Frank Thomasov doprinos SuperUser ima odgovor za nas:
Both. CMOS stores BIOS configuration information. When you enter setup, you are running the BIOS’s configuration program, which loads the settings defined in CMOS. You are “setting up” the CMOS by providing configuration information the BIOS will use as it runs.
The BIOS is a program written as firmware onto a ROM so that it cannot be written to (except by an all-or-nothing flash operation, which is dangerous, so not an everyday operation). The BIOS ROM stores its configuration information on the CMOS when you hit F10. That is why clearing the CMOS restores your BIOS settings to default and does not delete the BIOS itself, leaving you with an expensive paperweight.
For example, the BIOS has a subroutine that will load the operating system per the boot order. The boot order information, however, (i.e. use first CD-ROM as first device) is stored in the CMOS. If you clear the CMOS, the BIOS will use a default, usually the first disk on the first disk controller that is populated.
Imate li nešto za objašnjenje? Zvuči u komentarima. Želite li pročitati više odgovora od drugih tehnoloških korisnika Stack Exchangea? Pogledajte ovdje cijelu raspravu.
